Delivered to your door | Shipping policy changes as of 1st of JulyShipped icon

Cabots Cabothane Clear

Cabots Cabothane Clear WB

This clear polyurethane has been specially designed for doors, windows, trim and furniture. Highly durable, it’s hard wearing and has a fast drying finish. No Sanding is required

 

From: $21.80

Clear
Add to Wishlist
Add to Wishlist

Need assistance? Contact us

DESCRIPTION

Get your home looking its best with Cabot’s Cabothane Clear Water Based. This clear polyurethane has been specially designed for doors, windows, trim and furniture. Highly durable, it’s hard wearing and has a fast drying finish. No Sanding is required (refer to label for further instructions).
This clear polyurethane has been specially designed for doors, windows, trim and furniture. Highly durable, it’s hard wearing and has a fast drying finish. No Sanding is required. It is available in a Matt, Satin and Gloss finish.

Areas
Doors, Furniture, Trim, Windows

Clean Up
Water Washup

Recoat Time
2 Hours

Preparation

Note: Fill nail holes, cracks and other defects with Cabot’s Wood Tone Putty after applying the first coat of this product for accurate colour matching. Remove stains, dirt, wax, grease and oil with mineral turpentine. Remove any polish with a suitable polish remover. Note: Previously coated interior timber with highly visible scratches, imperfections or surfaces that are severely worn must be sanded prior to coating. Bare Interior Timber Sand the surface smooth using 180 – 240 grit sandpaper. Sand only in the direction of the grain. Remove all traces of sanding dust. Bare Exterior Timber To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions. Previously Coated Interior Timber

1. Thoroughly clean the surface with Cabot’s Floor Clean and allow to dry.

2. Apply one coat to a small test area. Allow to dry for 3 hours. Press sticky tape firmly to the surface and pull off quickly. If the coating comes off, sand back further to a sound surface. Previously Coated Exterior Timber For best results, remove back to bare timber using a paint stripper, or sanding. For exterior surfaces only, clean with Cabot’s Deck Clean following label instructions.

Application

1. Stir thoroughly with a broad flat paddle before and during use.
2. Apply with a good quality brush or spray gun. If spraying, back brushing is recommended. If brushing, always brush in the direction of the grain.
3. Allow to dry for a minimum of 2 hours. For best results, lightly sand to remove any grain raise using 230grit paper. Remover all sanding dust.
4. Apply 2nd and 3rd coats as per above.

Product Data Sheets

Cabothane Clear Satin
Cabothane Clear Gloss
Cabothane Clear Matt

Reviews

There are no reviews yet

Add a review
You must be logged in to post a review Log In

Paint Calculator

Disclaimer: Direct Paint Calculator is provided as a guide only, further details are available at the bottom of the page.

Hidden

Paint Colour

Select from Palette to see range of colours

Select a Sheen